Pengembangan Model Teaching Factory di Bengkel Otomotif SMK Karsa Mulya Palangka Raya

Galfri Siswandi, Pendidikan Teknik Mesin Universitas Palangkaraya, Indonesia
Sukoco Sukoco, Fakultas Teknik Universitas Negeri Yogyakarta, Indonesia

Abstract


The objective of the study is to develop an applicable Teaching factory model for practices in the automotive workshop of SMK Karsa Mulya Palangkaraya. This study used a quantitative approach. It was conducted in grade XI of Motorcycles Engineering Department at SMK Karsa Mulya Palangkaraya. It was carried out in five phases: (1) preliminary investigation, (2) design; (3) realization / construction, (4) test, evaluation and revision, (5) field testing / implementation. Data collection instruments consisted of observation sheets and assessment sheets. The results of the competency tests of 19 students were: (a) Tune Up; the highest score, the lowest score and the average score were 98.82, 89.41, 95.23 respectively (b) Over Haul; the highest score, the lowest score and the average score were 90.67, 82.67, 85.55 respectively (c) System Starter; the highest score, the lowest score and the average score were 80.00, 77.33, 78.00 respectively. Thus it was noted that the model can be applied in the vocational workshop of Motorcycle Engineering Department at SMK Karsa Mulya Palangkaraya

Keywords


Automotive Workshop, Practices, Teaching factory

Full Text:

PDF

References


Badan Pengembangan dan Pembinaan Bahasa. 1995. Kamus Besar Bahasa Indonesia. Jakarta: Balai Pustaka

Clarke, L., and Winch, C. 2007. Vocational Education: Internasional Approaches De-velopments, and System. New York: Rout-ledge

Dikmenjur. 1996 Pedoman Teknik Pelaksanaan Pendidikan System Ganda pada SMK, Depdikbud: Jakarta

Direktorat PSMK. 2006. Penyelenggaraan Se-kolah Menengah Kejuruan Kaitanya dengan Aspek Mutu Outcome Standar Nasional Pendidikan (SNP). Jakarta: Depdiknas

Direktorat PSMK. 2008. Roadmap Pengemba-ngan SMK 2010-2014. Jakarta: Departe-men Pendidikan Nasional

Edward V.W & Andrew D.A. 1976. Modern School Shop Planning Seventh Edition, Michigan: Prakken Pub,inc

Finch, C. R & Crunkilton. John. 1999. Curri-culum Development in Vocational and Technical Education: Planning, Content, and Implementation. Needham Heights, MA: Allyn & Bacon. Inc

Forester, W.J. 1973. Industrial Dynamics. Ma-ssachusetts, USA: The MIT Press

Hadlock, H. et al. 2008. From Practice to Entre-preneurship: Rethingking the Learning Factory Approach. Proceeding of the 2008 IAJC IJME International Confe-rence, ISBN 978-1-60643-379-9

Hamalik, Oemar. 2007. Kurikulum dan Pem-belajaran. Jakarta: PT. Bumi Aksara

Hasbullah. 2010. Implementasi Pabrik Penga-jaran (Teaching factory) untuk Mening-katkan Kompetensi Siswa SMK: Seminar Internasional, ISSN 1907 - 2066 Peran LPTK Dalam Pengembangan Pendidikan Vokasi di Indonesia: APTEK-INDO

Lamancusa, J.S. et al. 2008. The Learning Factory: Industry-Partnered Active Lear-ning. Journal of Engineering Education

Nayang Polytechnic. 2003. Teaching Factory Concept. Diambil dari http://www.nyp. edu.sg/seg/innovative-teachingnlearning/ the-teaching-factory-concept pada 14 Fe-bruari 2013

Orlich, D.C. et al. 2007. Teaching Strategies: A Guide to Effective Instruction. New York: Houghton Mifflin Company

Plomp, T. 1997. Educational & Training system Design: Introduction University of Twen-=te. Faculty of Education Science and Technology. Enschede, The Netherlands

School Shop Magazine and The Education Digest. 1982. Modern School Shop Planning. Michigan: Prakken Pub,inc.

Sema E. Alptekin, Reza Pouraghabagher, Patricia McQuaid, & Dan Waldorf Cal Poly. 2001. Teaching Factory. Procee-dings of the 2001 American Society for Engineering Education Annual Confe-rence & Exposition, San Luis Obispo, 3563

Siswanto, Ibnu. 2011. Pelaksanaan Teaching Factory di SMK RSBI Daerah Yogya-karta. Tesis Magister. Tidak diterbitkan. Yogyakarta: Universitas Negeri Yogya-karta

Stark, J.S & Thomas, A. 1994. Assessment and Program Evaluation. Massachusetts: Si-mon & Schuster Publishing

Storm, G. 1995. Managing the Occupational Education Laboratory. Michigan: Prak-ken Publications, inc.

Stufflebeam, D.L. & Shinkfield, A.J. 1985. Systematic Evaluation. Massachusetts: Kluwer-Nijhoff Publishing

Sugihartono. 2009. Kendala yang Dihadapi oleh Pihak Industri dalam Pendidikan Sistem Ganda. Diambil dari http://sugihartono1. wordpress.com/2009/11/04/pendidikan sistem ganda/ pada 14 Februari 2013

Sukardi, Thomas. 2008. Pengembangan Model Bengkel Kerja Praktik Sekolah Menengah Kejuruan. Disertasi doktor, tidak diterbit-kan, Yogyakarta: Universitas Negeri Yog-yakarta:

Their, Herbert D. 1970. Teaching Elementary School Science. A Laboratory approach. New York: Heath and Company

Usman, Husaini. 1998. Kepemimpinan Entre-preneur di Pendidikan Kejuruan, Ban-dung: Alfabeta




DOI: https://doi.org/10.21831/jptk.v22i4.7844

Refbacks

  • There are currently no refbacks.


Copyright (c) 2016 Jurnal Pendidikan Teknologi dan Kejuruan



 

Online (e-ISSN): 2477-2410 || Printed (p-ISSN): 0854-4735

Jurnal Pendidikan Teknologi Kejuruan by http://journal.uny.ac.id/index.php/jptk was distributed under a Creative Commons Attribution 4.0 International License.

View My Stats

Supported by:

Jurnal Ilmiah Magister Managemen

Social Media: