Developing Computer Assisted Media of Pneumatic System Learning Oriented to Industrial Demands

 Wahyu Dwi Kurniawan, Agung Prijo Budijono, Nur Aini Susanti

Abstract


This study aimed to develop learning media of pneumatic systems based on computer-assisted learning as an effort to improve the competence of students at the Department of Mechanical Engineering, Faculty of Engineering UNESA. The development method referred to the 4D model design of Thiagarajan comprising the steps of: define, design, develop, and desseminate. The results showed that the expert validation average score included in both categories was 3.54, indicating the learning application acceptable. A limited test showed effective results, namely: (a) Analysis of the data included in the category of learning was good (3.64), indicated by students’ enthusiasm in the learning process; (b) Teaching learning activities were categorized as good, the students actively involved in learning, and the most dominant activity was doing tasks while discussing; (c) Learning objectives were both achieved individually and classically; (d) The students showed a positive response expressed by the students’ interest, excitement, and motivation to follow the learning process.


Keywords


computer assisted learning, hydraulic pneumatic, learning media

Full Text:

PDF

References


Adi Dewanto, Dessy Irmawati. 2013. Pembelajaran sistem hidrolik dan pneumatik dengan menggunakan automation studio. Jurnal Pendidikan Teknologi dan Kejuruan. 21. 3. 262-268

Arikunto, S. 2001. Dasar-dasar Evaluasi Pendidikan. Jakarta: Bumi Aksara.

Ratumanan, T.G. dan Lourens, T. 2003. Evaluasi Hasil Belajar yang Relevan dengan Kurikulum Berbasis Kompetensi. Surabaya: YP3IT Kerjasama dengan Unipress

Slavin, Robert E. 2005. Cooperative Learning: theory, research and practice (N. Yusron. Terjemahan). London: Allymand Bacon

Thiagarajan, S. Semmel, D.S., and Semmel, M.I. 1974. Instructional Development for Training Teachers of Exceptional Children. Minneapolis: Indiana University

Wahyu Dwi Kurniawan, Agung Prijo Budijono. 2013. Pengembangan Perangkat Pembelajaran Mekatronika Berbasis Komputer Pokok Bahasan Programmable Logic Controller Berorientasi pada Pembelajaran Langsung. Jurnal Pendidikan Teknologi dan Kejuruan. 21, 191-202

Yatin Ngadiyono. 2009. Pengaruh Strategi Pengulangan terhadap Kemampuan Retensi Belajar Pneumatik Mahasiswa Pendidikan Teknik Mesin UNY. Jurnal Pendidikan Teknologi dan Kejuruan. 18.1, 129-149




DOI: https://doi.org/10.21831/jptk.v23i3.13417

Refbacks

  • There are currently no refbacks.


Copyright (c) 2017 Jurnal Pendidikan Teknologi dan Kejuruan

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

 

Online (e-ISSN): 2477-2410 || Printed (p-ISSN): 0854-4735

Lisensi Creative Commons
Jurnal Pendidikan Teknologi Kejuruan by http://journal.uny.ac.id/index.php/jptk was distributed under a Creative Commons Attribution 4.0 International License.

View My Stats