PENGARUH BAHAN TAMBAH POTONGAN LIMBAH MATERIAL PLASTIK TERHADAP KUAT TEKAN BEBAS PADA TANAH LEMPUNG WATES

Authors

  • Muhammad Siddiqi Hajar, Dian Eksana Wibowo

DOI:

https://doi.org/10.21831/inersia.v10i2.9967

Abstract


ABSTRACT
This research aims to classification clays in Kasongan Bantul based of AASTHO (American
Association of State Highway and Transportation Officials Classification) and to find out the
highest number of qu by using a mixed pieces of plastic material waste in percentage 0%,
1%, 2%, and 3%. This research was conducted in laboratory soil mechanics the Department
of Civil Engineering and Planning, Faculty of Engineering, Yogyakarta State University. The
results showed that Clays in Kasongan Bantul based of AASTHO is classified A-7-6 (11) that
is medium to low; the plastic material waste reveals the highest number of qu, that is on 3 %
that is 0,91286 kg/cm2; 2% that is 0,77660 kg/cm2; 1% that is 0,77354 kg/cm2; and 0% that is
0,65345 kg/cm2.
Keywords: Clay, plastic material waste, unconfined compression test

Author Biography

Muhammad Siddiqi Hajar, Dian Eksana Wibowo


Muhammad Siddiqi Hajar1, Dian Eksana Wibowo2
1,2Jurusan Pendidikan Teknik Sipil dan Perencanaan FT UNY
eksa.prince@gmail.com

Downloads

How to Cite

Dian Eksana Wibowo, M. S. H. (2016). PENGARUH BAHAN TAMBAH POTONGAN LIMBAH MATERIAL PLASTIK TERHADAP KUAT TEKAN BEBAS PADA TANAH LEMPUNG WATES. Inersia : Jurnal Teknik Sipil Dan Arsitektur, 10(2). https://doi.org/10.21831/inersia.v10i2.9967

Issue

Vol. 10 No. 2 (2014): Desember

Section

Articles

License

Authors who publish with INERSIA journal agree to the following terms:

  1. Authors retain copyright and grant the INERSIA journal right of first publication with the work simultaneously licensed under Creative Commons Attribution License (CC BY 4.0) that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
  2. Authors can enter into separate, additional contractual arrangements for the non-exclusive distribution of the published version of the work (e.g., post it to an institutional repository or edit it in a book), with an acknowledgment of its initial publication in this journal.
  3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) before and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.
Lisensi Creative Commons
INERSIA by https://journal.uny.ac.id/index.php/inersia was distributed under a Creative Commons Attribution 4.0 International License